The Mercedes Sprinter / Freightliner Cutaway Cab Back Close Out from Blackhawk Fiberwerx is engineered for durability, proper fitment, and flexibility in commercial, RV, and specialty vehicle builds. Constructed from high-quality fiberglass, this cab back provides a solid rear cab enclosure designed specifically for the Sprinter cutaway chassis.
Standard Configuration
Supplied without rear window cut-out
Fiberglass exterior ready for paint or finishing
Designed for Mercedes Sprinter / Freightliner cutaway chassis
Window Option
Rear window opening can be cut out upon request
Compatible with 2019+ Mercedes Sprinter window glass and seal
Window glass and seal not included (sold separately)
Interior Finish Options
Standard Interior (Unfinished)
Supplied with an unfinished fiberglass interior. May be left as-is or finished by the builder to suit their specific application.
Gel Coat Interior (Optional)
Finished gel coat surface for a cleaner appearance and easier maintenance.
Carpeted Interior (Optional)
Carpet-lined interior for improved sound reduction and thermal insulation.
(Interior finish options are available across all cab back models.)
Installation
Note: All trucks may vary slightly. Minor adjustment during installation is normal.
Mock up the cab back to the chassis using clamps and check fitment. Some play is normal and allows for adjustment during installation.
Mark mounting hole locations. Installation kit hardware uses 3/8″ bolts. Drill holes or use existing chassis holes as applicable.
For newer Ford chassis (2017 and up), U-clips or J-clips with matching screws can simplify installation.
Apply sealant to the chassis around drilled holes to prevent water or debris from entering the cab.
If the cab back requires floor bracing (24″ depth and larger), determine brace locations. These can be adjusted later if needed.
Clamp the cab back to the chassis, then install nuts, bolts, and fasteners. Tighten gradually, alternating from side to side, and adjust alignment as necessary.
Due to chassis variation, a small gap may exist where the floor meets the cab back. This can be addressed using metal, treated wood, spray foam, rubber gasket material, or similar methods.
To seal the exterior seam, apply painter’s tape to both the cab back and chassis sides near the seam. Apply sealant between the tape lines, then remove tape for a clean finish.
For cab backs 24″ and larger: Attach the angled metal bracket to the floor and use the flat 4×4 attached to threaded rod to provide additional floor support.
Designed for installation by professional upfitters or experienced do-it-yourself builders
Optional installation kit available
Shipping & Ordering Information
Due to the size of this product, shipping is handled via LTL freight and must be quoted separately.
Online checkout is currently unavailable.
To place an order or request a shipping quote, please contact us directly by phone or email and we will assist you with the ordering process.